14
INTERIOR STRIP LIGHTING
Your QBRE may be equipped with 12 volt strip lights mounted on the ceiling. The specifications for these
are listed below.
A. DC input voltage (continuous)
8-16 VDC
B. DC input voltage (peak)
20 VDC 30 sec.
C. DC input current
(with dual F13T5 tubes)
2.4 A
D. RMS output current
130ma @ 13.2 VDC input
E. Operating frequency
(with normal load)
56 khz
F. Peak output firing voltage
880 V
G. Lamp types
F4T5 through F13T5
H. Starting
Ballast incorporates a proprietary solid state lamp start-
ing circuit which preaheat-starts lamps and disallows de-
structive cold starting for exceptional lamp life, typically
> 20,000 starts.
I.
Transient protection
Protects ballast from defective tubes or arcing sockets.
J.
Operating temperature range
-17 deg. C / 0 deg. F to 65 deg. C / 150 deg. F
K. Protection
Over temperature and reverse polarity protected.
L. Length
48 inches
M. 12V Part No.
905-02-006
N. Tube requirements
2-F13T5CW
CIRCUIT BREAKERS
Body and chassis circuits are protected by
circuit breakers located in a side mounted elec-
trical box below driver’s window. If a short
occurs and the circuit breaker breaks, the cir-
cuit will reset itself when the element cools. A
short may be indicated by blinking of lights or
fluctuating gauges. The shorted circuit should
be corrected immediately.
For access to the electrical panel, locate
latch release as shown. Push latch release
downward. This will enable the access door
located on the outside of bus below the driver’s
window to open.
RELEASE LATCH
DRIVER'S SEAT
