Blastrac 200VMB, Руководство по эксплуатации

Страница: 18 / 35

18
6.1 Changing the mouth seal complete

Pull off all 4 rubber springs from the threaded ends.

Remove mouth seal complete from the housing.
Assembly of a mouth seal complete
Be sure that all rubber plates are in one line. If plates are not mounted in one line, the mouth seal will not
move easy back and forwards. Do not over tighten the nuts, the plates must not be pressed in.
(4x) Angle strip – E09646
Mouth seal front plate
E10461
(12x)
M6x20 Countersunk bolt /
Washer / Lock nut.
The countersunk head
must be equal with the
rubber plate when
fastened.
(4x)
Mouth seal bolt short
E10467
(4x)
Mouth seal bolt long
E10466
(6x) M8x60
Countersunk Hex.
Sockethead screw
(2x) Magnet – 969763
(2x)
Mouth seal magnet plate
E10463
(3x)
Mouth seal back plate
E10464
(12x) M8 Lock nut/
Washer Ø25
Do not overtighten.
Rubber plates must not
be pressed in.
(4x)
Rubber spring – E09288
+
M8 Lock nut/ Washer Ø25
Rubber plates must
be in one line.
(1x) Magnet – E12229