Blastrac 200VMB, Руководство по эксплуатации

Страница: 31 / 35

31
Contaminated abrasive The dust collector is not generating
enough suction power so that dust
remains in the abrasive.
Clogged dust hose
Ripped or damaged dust hose Check the dust collector (filter, dust
hopper and seals)
Check and clean the dust hose
Replace dust hose
Excessive wear in blast
housing and rebound
plenum Wrong abrasive.
Incorrect setting of the control cage Contact Blastrac .
The thrown abrasive blasts the housing
and not the surface to be blasted. Adjust
the blast pattern.
Blast wheel motor does
not switch on Motor protection switch has triggered. Check and switch on again. Check the
mains power supply.
Blast wheel motor
switches off during
operation Safety fuse or fault current breaker has
triggered.
Connection cable is defective.
Cables connecting the units (winches,
motors etc.) are defective.
Motor protection switches have triggered. Have the fault checked by an electrician.
Replace the cable.
Replace the cable(s).
Have the fault checked by an electrician.
Note: If the motor protection switches of the blast wheel motors have been triggered by overload, they can be
switched on again after a short cooling down period.