Blastrac 200VMB, Руководство по эксплуатации

Страница: 13 / 35

13
5.3 Switch on the machine
 Before switching on the blast machine, switch on the dustcollector 200DC.
If the underpressure is OK, indicator (#8) will light up green.
 Lift the machine a little bit above the ground and allow it to suck to the wall.
The WALL SENSOR OK indicator (#7) will light up green.
 Press the green button “ START Blastmotor ” and check the rotating direction of the blast motor. The
correct direction is given with an arrow on the housing of the motor.
 Keep a safe distance behind the blast machine.
 Move the machine 1 meter up and down to make sure everything is OK.
 Move the machine up again and when the machine is traveling, open the shot valve (#10). Observe
the ammeter on the display.
Maximum blast wheel amperage = 14.5 Ampere. Adjust the load
amperage by opening or closing the shot valve. After having blasted approximately 2 meter, close the
shot valve(#9), stop the machine (#2) and check the blasted surface.
 If the ‘hotspot’ must move to the right, turn the cage a little bit to the right. Never adjust the cage
during blasting ! Loosen the nuts (#11) of the window indicator and adjust the position to the right.
Tighten the nuts after adjusting.
 If the ‘hotspot’ must move to the left, adjust the window indicator to the left.
1 2 3 4 5
Emergency
stop
button STOP
Blastmotor START
Blastmotor Connection
for control
cable Ampere-
meter /
ammeter
6 7 8 9 10
Warning
light
MOTOR
FAILURE Indicator
WALL
SENSOR
OK Indicator
PRESSURE
OK CLOSE
Shotvalve
button OPEN
Shotvalve
button
1 4 5
6 7 8 9
1
0
3 2
1
1