Blastrac 200VMB, Руководство по эксплуатации

Страница: 11 / 35

11
5. Operating
During operating the 200-VMB, the following additional safety instructions must be followed closely.
Before switching on the machine make sure that no-one can be endangered when the machine starts up.
Make sure that no vehicles, such as forklift trucks and other equipment run over the electric cable and the dust
hose.
5.1 Before switch on

Fill the shot hopper with the selected abrasive (max. 62 kg.)

Move the Abrasive-Level-checker up and down, so it will show the level of
abrasive in the machine.

Check the level regularly. When level is too low this could wear out the abrasive
valve in short time.

The magnets of the mouth seal must be covered over the whole surface with
abrasive.

Connect the blast machine and dustcollector (200DC) with the dust hose. This connection must be
reliable with a hose clamp and tape.

Connect the cables between the blastmachine, the electrobox and the control panel:
Connect Machine(A) and Electrobox(A) with the supplied cable.
Connect Machine(B) and Electrobox(B) with the supplied cable.
Connect Electrobox(C) and Control panel(C) with the supplied cable. Use the snap-hooks and attached
lifteyes to secure the connection.

Connect the power supply cable of the dustcollector 200DC and blastmachine’s mains power supply
with the generator. Be sure that electrical power supply is correct.
All persons in the proximity of the machine must wear safety glasses with lateral
protection as well as safety shoes and ear protection. The operator is obliged to wear
close-fitting protective clothing and a dust mask.
Full
Empty
A
A
B
B
C
C
ELECTROBOX
CONTROL PANEL
MAINS POWER SUPPLY
Cover magnets
with abrasive