BT-750 Operator Manual 16
P/N : OPM(BT-750)EN Bistos Co.,Ltd. Rev.02(2013.04.12)
Connect the accessories for measurement to each mating port of the equipment.
3.5.4 Replacing Roll paper
①
Verify if the printer is receiving the data, otherwise it will lose the receiving data.
②
Open the printer door by pushing the button at the both side of the printer slightly as
shown the figure below.
③
insert a new paper roll oriented properly like above figure, after verifying the direction of
the paper. Remove the empty paper core and insert a new paper roll oriented properly.
④
Pull the paper out towards you until approximately 2 inches of paper and align the paper.
Close the printer door.
Caution
● When the printer door is not perfectly closed, the printing could
not be operated or printed clearly.
● When printing more than 1 minute, the overheating of the printer
could be faulty. In this case, stop the printing at least 3 minutes.
● Please use the right paper and do not use the core adhesive roll. If
you use it, it may occur the malfunction as the printer fails to find the
end of the paper.
