Bionet SpiroCare, Руководство по эксплуатации

Страница: 34 / 135

34/135
SCOMBA-1.1
SpiroCare Operation Manual
1) Connecting Spirometer Handle
Spirometer handle should be connected to the main body by plugging in the end of its
cable to serial input port in the main body (shown below)
<Rear View>
(1) Connect spirometer handle to main body while the power of the main body is off.
(2) Turn on power switch of main body.
(3) Turn on power switch of spirometer handle.
Verifying Spirometer Handle’s status
Spirometer handle is in correct status if green lamp is lit after the user set the power
switch, located on the right side of the handle, to up position.
2) Installing Mouthpiece
To start spirometer measurements, mouthpiece should be inserted in spirometer handle.
Start by first pressing ‘Upper cover lock’ in the upper left side of spirometer handle. Then
open semicircle upper cover to insert the mouthpiece into a groove made in open side.
Finally, close the upper cover to finish mouthpiece installation, by giving it a little pressure
on top. For correct placement of mouthpiece, make sure mouthpiece tube is longer in
the front side of the spirometer handle than that in the back side
(1)
First press ‘Upper cover lock’ in the upper
left side of spirometer handle to open
semicircle upper cover.
(1)