Biolase Waterlase iPlus, Руководство пользователя

Страница: 35 / 82

35
8
Operating Instructions
Tips
Tip selection will always correspond to the selected Handpiece. The names
of the respective Tips are shown below each image for reference. When
Tip Selection is active, the recommended Tip is highlighted, preferred Tips
for the Handpiece are outlined, and all the Tips allowed for the speci�c
application are shown on the screen (Fig. 8.6).
• Press the image of the Tip (which may or may not be the recommended
Tip);
• Both Cooling Air and Patient (spray) Air will turn ON;
• Replace the Tip.
Fig 8.7
Fig 8.8
Fig 8.6
Waterlase iPlus User Manual
To return to the Procedures screen once the Tip is installed, press either the
back or Handpiece button located at the bottom of the display.
Laser Power
Laser Power settings, as well as pulse repetition rate and laser pulse mode
are always defined by the procedure type and the selected Tip (Fig 8.7).
The Pulse mode button switches the system between S (long pulse) and H
(short pulse) modes. Laser parameters can be changed at any time in
Ready or Standby modes. After adjusting these settings, press the Back or
Laser button at the bottom of the display to return to the Procedure screen.
Spray
Spray settings for air and water percent can also be adjusted while in
Ready or Standby (Fig 8.8). Mode selection scrolls between ON, OFF and
AUTO for both parameters.
CHANGING AND SAVING THE PRE-SETS
When system parameters are changed from the factory pre-sets, the "star"
symbol visible in the highlighted procedure mode on the left side of the screen
changes to an "unlocked lock" symbol, indicating that the system pre-set
parameters have been modified but not saved.
To save modifications to any settings, press and hold the specific procedure
mode for 2 seconds. The "unlocked lock" symbol will change to a "locked lock"
symbol, indicating that the settings have been saved. Otherwise, the
modifications will be lost when proceeding to a different screen.
To restore the factory pre-programmed settings for the customized procedure
mode (indicated by "locked lock" symbol), press and hold the corresponding
name of the step for 2 seconds. The "star" symbol will re-appear in place of the