Biocare iM 12, Руководство пользователя

Страница: 89 / 196

Chapter 6 Parameter Monitoring
User Manual of Veterinary Monitor --77--
6.7.2 Safety Information
Warning

Pressure sensors specified in this User manual only are allowed to be used and repeated use of
disposable pressure sensors is not allowed.

Contact of the monitor
‟s sensors and cables with high-frequency surgical equipment should be
avoided in order to prevent animals from being burnt by leaked current when the monitor is in
contact with high-frequency surgical equipment.

Contact of accessories with electrically connected metallic parts should be avoided while
connecting and using such accessories.

The working temperature of such accessories should be considered when they are used; and
please refer to the Accessory Use Manual for more details.

If the packaging of the invasive pressure sensor marked for disinfection is damaged, please stop
using it and contact the provider of the invasive pressure sensor.

If the pressure sensor and conduit are damped, please stop using it and contact the provider of the
invasive pressure sensor.
Attention

Before monitoring, please zero-calibrate first.

Make sure that the pressure sensors are constantly leveled with the heart during monitoring.

Please continuously inject heparin saline to flush conduits to prevent them from being clogged and
maintain the pressure-measuring paths are smooth while connecting the conduits firmly to prevent
them from any displacement or separation that would affect the IBP measure.
6.7.3 Monitoring Steps
1 Insert the pressure transducer extension cables into the IBP interface on the monitor‘s left panel.
2 Prepare flushing solution.
3 Flush the system and deflate the conduits completely. Make sure no bubbles exists in the sensors and valves.
4 Connect the pressure tube and animal conduit.
5 Place the sensor on the same level with the heart, approximately at the midaxillary line.
6 Select correct label.
7 Zero-calibrate the sensors. Close the sensor‘s valves toward the air and open the valve in connection with the
animal when the zero-calibration is completed.
Figure 6.37 IBP Monitor Connection Diagram