Biocare iM 12, Руководство пользователя

Страница: 117 / 196

Chapter 6 Parameter Monitoring
User Manual of Veterinary Monitor --105--
6.10.6 AG Setup
Figure 6.60 AG Setup

Apnea Delay
Set the Apnea delay time; when the animal suffocation time exceeds the set value, the monitor will trigger an
alarm.

Setting Waveform
In AG settings menu:

Set up [CO
2
Wave Fill]:
[Off]: describe CO
2
waveform with lines.
[On]: the area below CO
2
waveform is displayed by filling.

Select [Sweep]: select the appropriate settings in the pop-up list; the waveform speed: 6.25 mm/s, 12.5
mm/s, 25 mm/s. The larger the value, the scanning speed is the faster, and the waveform is wider.

Adjust the waveform ruler (CO
2
, AA ruler, N
2
O ruler, O
2
ruler) and the waveform amplitude changes
accordingly.

Operating Mode
For detailed, please refer to the content of 6.8.4 CO
2
Setup- Operate Mode.

O
2
Compen
Warning

Please set O
2
compensation to meet different actual conditions, otherwise, the measured results
may deviated greatly and result in misdiagnosis.
6.10.7 Replacing Anesthetic
If the anesthetic used on the animal changes, the mixing of the two gases can be detected by the module during the
transition period. However, the time required for anesthetic exchange depends on the type of anesthesia (low flow
or high flow) and the properties of anesthesia. The anesthesia module can automatically identify the two
anesthetics. When there is a greater change between the primary and secondary anesthetic gas components, the
monitor will determine the dominant anesthetic according to the contribution to MAC value, thereby replacing the
mark and data of displayed dominant anesthetic.