16
the sensors (R), located on the
handlebar, as shown in Fig.6.
When both hands are placed on the
sensors the heart symbol on the
screen will begin to flash and after a
few seconds your heart rate reading
will be displayed.
If both hands are not placed correctly
Fig.6 then the pulse function will not
work.
If a “P” appears on the screen or the
heart symbol does not flash then
make sure that both hands are placed
on the sensors and that connector (Z)
is connected at the back of the
monitor (P).
SAFETY INSTRUCTIONS.-
Always follow this advice when using
electrical appliances.
- Make sure that the mains supply
voltage is suitable for the machine
before plugging it in.
The supply voltage should be 220 V
and the wall socket outlet must match
the plug on the machine. Do not use
any type of adapter.
- To reduce the risk of electrical shock,
always unplug the unit immediately
after use and before attempting to
clean it.
- Never leave the unit unattended
when it is plugged in. Unplug it after
use.
- Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
- Never use accessories that are not
recommended by the manufacturer.
- Do not use the machine if the mains
cable becomes damaged or worn.
- Keep the mains cable away from hot
surfaces.
- Do not use the machine outdoors or
in the rain.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid cristal display. Similarly, do
not expose it to water or knocks.
TROUBLESHOOTING GUIDE.-
Problem:
The display comes on but
only the Time function works
Solution:
a.- Make sure that the connection
cable is connected.
Problem:
The display does not come
on or the displayed segments are very
weak
Solution
:
a.- Check that the transformer is
plugged in.
b.- Check the voltage output from the
transformer.
Problem:
Display segments of a
function read-out are not visible or
error messages for a particular
function appear.
Solution:
a.- Check that cables (p) and (p1) are
connected properly. Please refer to
the assembly manual, Fig.4B.
b.- Check that cable (M) is plugged
into the monitor socket (N) correctly.
c.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
Содержание H-493
Страница 2: ...Fig 1 Fig 2 Fig 3 Fig 4...
Страница 3: ...Fig 5 Fig 6...
