BEST ACCESS SYSTEMS 34HW, Руководство по обслуживанию, Страница: 86 / 228

Service and Maintenance for Mortise Locks
4–32 W Series Service Manual
Task H. To remove the mortise case:
1. Remove the two case mounting screws.
2. Remove the case from the door.
Reinstalling
components for
electrified mortise
locks
The next three sections outline the tasks to perform in order to reinstall
components for electrified mortise locks with different types of trim.
Each section references the appropriate trim diagrams in Chapter 3 and
the detailed instructions for each task found in
Tasks for reinstalling
the components .
Reinstalling the sectional trim and mortise case
Refer to the trim diagram on page 3–5 and the detailed instructions for
each task listed below.
1. Perform Task A. To reinstall the mortise case ( page 4–33 ).
2. Perform
Task B. To reinstall the mounting plates
( page 4–35 ).
3. Perform Task D. To reinstall the roses ( page 4–36 ).
4. Perform Task E. To reinstall the rose rings ( page 4–36 ).
5. Perform Task F. To reinstall the cylinder ( page 4–37 ).
6. Perform Task G. To reinstall the mortise case faceplate
( page 4–39 ).
7. Perform Task H. To reinstall the levers/knobs ( page 4–39 ).
Figure 4.31 Removing the mortise case
Case mounting screws