BERTHOLD TECHNOLOGIES LB 567, Руководство пользователя

Страница: 174 / 186

Chapter 11. Error Lists and Device States
78
MicroPolar 2 (++) LB 567
11.3 Measurement Error and Error Prompts
Code Error Possible cause
50 Sigma of phase is
too large The measured phase ex-
ceeds the allowed Sigma
limit.
54 No system calibra-
tion done The system calibration has
not yet been carried out.
55 Insertion attenua-
tion is not reached. See Software Manual, chap-
ter 8
60 Current in 1 out of
range The enabled current input
has not yet been calibrated
or is not occupied.
61 Current in 2 out of
range The enabled current input
has not yet been calibrated
or is not occupied.
62 PT100 temperature
out of range The enabled PT100 input has
not yet been calibrated or is
not yet occupied.
70 Concentration out
of range The concentration is outside
the process limits.
71 Concentration 2 out
of range Concentration 2 is outside
the process limits.
72 Loading value 1 be-
low minimum load Below the minimum load for
concentration 1
73 Loading value 2 be-
low minimum load Below the minimum load for
concentration 1
74 Loading compensa-
tion inactive current
input
upper & lower limit
invalid Current input is outside the
range.
90 Current output 1
out of range The concentration calculated
on the basis of the current is
outside the current range
91 Current output 2
out of range The concentration calculated
on the basis of the current is
outside the current range
120 Date/Time
not set Please enter the date and
time.
For all other error messages, please contact the Berthold
Technologies Service.