BERTHOLD TECHNOLOGIES LB 567, Руководство пользователя

Страница: 149 / 186

Chapter 7. Calibration Conveyor Belt/Chute
MicroPolar 2 (++) LB 567
53
Chapter 7.
Calibration Conveyor Belt/Chute
Note: The measuring system must have reached normal operat-
ing temperature (approx. 45 min. warm-up time)).
Prerequisite:
Chapter 5. Configuration
have been completed.
7.1 System Adjust
Two reference measurements are used for system calibration.
There are two options:
a) microwave reference measurement on an empty belt and/or
chute (regular case)
b) microwave reference measurement with regular belt loading or
chute filling
Both procedures concern the optimization of the reference path.
They will be used for the phase adjustment in order to avoid phase
jumps that may be caused by a less than optimum geometry.
Normally, the reference measurement is carried out with empty
belt or chute. The belt (chute) should
run empty, clean and dry
.
If you later get high values - under normal operating conditions -
for Sigma (> 500), you have to carry out the reference measure-
ment with full belt or chute (= with normal load in the operating
point). In this case, a "tare" measurement with empty belt or
chute has to be carried out.
Starting from the main menu:
SETUP
CALIBRATION
1 | - | LB 567 | 07.05 – 13:25
Live Display
Diagnostic
Setup
Access Level User Mode
Language English
RUN ▲ ▼ ►
1 | - | Setup | 07.05 – 13:25
Configuration
Calibration
Input / Output
Service
Product
Change password
⌂◄ ▲ ▼ ►