BERTHOLD TECHNOLOGIES LB 567, Руководство пользователя

Страница: 173 / 186

Chapter 11. Error Lists and Device States
MicroPolar 2 (++) LB 567
77
Chapter 11.
Error Lists and Device States
The LEDs indicate the device status. Once the errors have been
corrected, the measurement returns to the state before the error
occurred. An acknowledgment is not required.
11.1 Hardware and Error Prompts
Code Error Possible cause
14 Battery volt-
age Battery power is low, replace im-
mediately,
see Hardware Manual, chapter 5.4
20 Caution!
Ambient tem-
perature too
high! Check operating temperature of
the evaluation unit, permissible
range:
-20 to 50° C or 45° C
21 HF tempera-
ture out of
range Check operating temperature of
the evaluation unit, permissible
range:
-20 to 50° C or 45° C
32 Parameter
memory
faulty Compatibility check after software
download: A general reset must
be carried out.
39 HF hardware
failure Faulty cable connection between
the motherboard and HF unit.
Check connector on the mother-
board.
Caution! First, disconnect the
evaluation unit from the power
supply!
For all other error messages, please contact the Berthold
Technologies Service.
11.2 Input Error
Error Probable Cause
Value too
large Input value is too large
Value too
small Input value is too small
Table is
empty Sampling has been selected without
previous sample measurement
Chart data
faulty The measuring system has determined
faulty chart data during calibration.
No chart data
available The calculated chart data have been de-
leted or calibration has not been com-
pleted.
Sampling full You have tried to measure more than 30
samples.