BERTHOLD TECHNOLOGIES LB 567, Руководство пользователя

Страница: 133 / 186

Chapter 4. Software Functions
MicroPolar 2 (++) LB 567
37
TIP
If you select a product for the first time (product 2 to 4),
all settings and contents of the current product will be cop-
ied to the new product, including:
- Configuration data
- System adjust
- Calibration data (including sampling table)
- Input/Output definitions
To switch over all 4 products, DI 3 also has to be set to prod-
uct. Please take the terminal configuration from the table be-
low.
Terminals DI 2
13 / 25
DI 3
14 / 26
Product 1 open open
Product 2 closed open
Product 3 open closed
Product 4 closed closed
4.2.31 Service
Factory setting and General reset:
See table on the next side.
Memory Tool:
Refers to the communication with the external memory
tool (optional accessory). Data transfer takes place via the
9-pole SubD-connector on the bottom of the instrument.
•
Save parameters: All instrument parameters for all
products will be saved to the memory tool.
•
Load parameters: All instrument parameters stored on
the memory tool will be loaded onto the evaluation
unit. All operating parameters in the evaluation unit will
be deleted.
•
Save datalog: The datalog will be saved to the memory
tool.
•
Save log: The start-up log will be saved to the memory
tool.
The concentration average value is put on hold during communica-
tion with the memory tool. Thus, the measured value via current
output is also put on hold!
1 | - | Service | 07.05 – 13:25
Factory setting
General Reset
Memory Tool
Data printout
⌂◄ ▲ ▼ ►