BERTHOLD TECHNOLOGIES LB 567, Руководство пользователя

Страница: 56 / 186

Chapter 4. Getting Started
56 MicroPolar 2 (++) LB 567
4.4.4 Installing the Evaluation Unit
Installation of the evaluation unit as described in chapter 4.2.2 .
4.4.5 Connecting the HF Cable
Connection of the HF cables as described in chapter 4.2.3 .
4.5
Connecting the Evaluation Unit
Electrical hazards:
Disconnect power to rule out any contact with live parts during
installation and servicing.
Turn off power before opening the instrument.
NEVER work on open and live instruments.
Caution! Potential hazards, material damage!
Device type:
LB 567-02 MicroPolar 2 (ID no. 41988-02) and
LB 567-12 MicroPolar 2 ++ (ID no. 54563-02)
When connecting the 24 V DC power supply, the + and – poles
must be connected correctly. There is no reverse polarity pro-
tection!
The line cross-section the for power supply must be at least 1.0
mm
2
.
Connect all desired input and output signals to the terminal
strip as shown on the following pages. Use the M feed-through
to keep the degree of protection.
Check if the voltage indicated on the type plate matches your
local supply voltage.
Connect the deenergized power cable to the terminals 3(L1),
2(N) and 1(PE).
Verify that the test switch (power interruption) is in position
"ON" (see Figure 5-1).
Close the instrument housing and turn on the power supply.