BERTHOLD TECHNOLOGIES LB 567, Руководство пользователя

Страница: 166 / 186

Chapter 9. Calibration and Advanced
70
MicroPolar 2 (++) LB 567
Sample measurements are carried out continuously over the en-
tire measuring range with the display depicted to the left. See
chapter 6.3 Sampling
After completion of sampling, the individual samples will be
enabled or disabled during input of the laboratory values, rel-
ative to the set split values. All samples smaller or equal to the
split value will be assigned to the lower concentration range
and all samples above to the upper concentration range.
The assignment of the samples is carried out automatically,
for example, by setting the split value or by entering the lab
values have been entered (e.g. after re-sampling). The assign-
ment depends on the split value and the lab value.
IMPORTANT
The split value entry allows you to enable samples that have
been disabled earlier through automatic assignment! In these
cases, disabled samples should better be deleted or disabled
again after a split value entry!
The split value to be set must correspond to the point of intersec-
tion of both calibration curves. This will be corrected automatically
after the calibration (within certain limits).
SPLIT VALUE
Enter the split value and confirm with .
√ . .
Push
⌂◄
to get to the Calibration page.
1 | - | Live Display | 07.05 – 13:25
Concentration av.
65.50
%
Conc. av. Conc. act. 64.35%
ESC SAMPLE .. ▲▼ .. ZOOM
1 | - | Advanced | 07.05 – 13:25
Tare values
Num. Cal. Sweeps 40
Process type Split Conc
Split Value 75.00 %
⌂◄ ▲ ▼ ►
1 | - | Advanced | 07.05 – 13:25
Split Value
75.00 | %
ESC .. ? .. DEL .. √ ..