10
111660 Rev C 5-13-14
Using the 0 through 9 buttons on the preset keypad,
enter an amount. If an error is made, press the
CANCEL
button and start over.
Example: If you have correctly entered a $5.00 sale,
the display reads as in Figure D-3.
2. Remove the nozzle from the holder.
3. Lift the handle to the
ON
position. Note: Ensure the
pump is authorized by the console or is in stand
alone mode.
NOTE: If an error is discovered at this point, the
preset amount can be changed before the
flow of fuel. The preset amount can be
canceled once flow begins.
NOTE: If the dispenser is a single hose dispenser, a
grade button must be pressed to start a
sale.
NOTE: If fueling doesn’t begin within 60 seconds of
starting the sale then the preset will reset to
Full Tank.
4. Squeeze the nozzle trigger to dispense fuel into the
vehicle or approved container.
5. Release the nozzle trigger when the dispenser stops
the flow of fuel.
6. Lower the handle to the
OFF
position.
7. Put the nozzle in the holder.
If the dispenser stops during delivery of fuel, refer to the
section in this manual entitled “How to Use
Diagnostics”, page 56.
Figure D-3
Figure D-4
The preset amount is
$ 5.00
Press cancel for Fill-up
7
6
8
5
9
4
3
2
1
0
The preset amount is
35 gallons
Press CANCEL for
Fill-up
7
6
8
5
9
4
3
2
1
0
How to Operate the Dispenser