bellagio Digital Entry System
PD
–
281 Issue 1
Installation and Operating Manual
Page 41 of 52
Special addressing
On the rare occasion when flat numbers skip every other number, e.g. 1,3,5,7 etc or
2,4,6,8 etc the jumper on the ‘PROG’ 6 pin header can be moved to pins 3 and 4.
If flat numbers are required in the range 3200 to 6400 the jumper on the
‘PROG’ 6 pin
header can be moved to pins 5 and 6. This simple adds an offset of +3200 to any address
set on SW6 and SW7.
Alphanumeric Flat Numbers
Flat numbers requiring alphabetic characters ( eg A1-A8, B101-B108, 101C-108C) cannot
be programmed on the Isolator switches and must be individually programmed from the
entrance panel. Please contact Bell System for instructions in this case.
Phone ring test
This can be used to ring a phone on one of the 8 outputs and see off hook and lock button
operation. It does not test the speech.
1. Press the Test button twice to ensure the system is in idle
2. Set SW7 to test the appropriate phone (only one phone at a time):
1 ON
1
st
Phone
2 ON
2
nd
Phone
3 ON
3
rd
Phone
4 ON
4
th
Phone
5 ON
5
th
Phone
6 ON
6
th
Phone
7 ON
7
th
Phone
8 ON
8
th
Phone
3. Press Test to ring the phone.
4. If the phone is taken off-hook the speech light will come on and go back off when
the phone is replaced.
5. If the lock button is pressed the status LED will come on for 3 seconds, if using the
BS-LX phone the green LED on the phone will also come on for 3 seconds.
6. Press the test button at any time to cancel.
7. Restore SW7 to the required address setting
