Belden Miranda DENSITE 3+ FR1, Руководство пользователя

Страница: 20 / 65

6
Densité 3+ FR1 Housing Frame
Using Densité 2 cards in the Densité 3+ FR1 Frame
3 Position the new panel and secure it in place with the captive screw(s) on the right-
hand side.
To remove and/or install a card
1 Open the front door of the frame
2 To install a card into an empty slot, slide the card into the slot with the swivel handle to
the right, and push gently on the handle to seat the connectors. If the card requires a
double-width rear panel to accommodate a large number of connectors, it should be
inserted into the lower slot. Inserting the card into the wrong slot will not damage the
card, and will be flagged by the on-card status LED flashing red to indicate that there is
no connection to the rear panel.
N.B. the rear panel must be installed before the card.
3 To remove a card from a slot, tilt the swivel handle on the front of the card to lever the
connectors apart, then use the handle to pull the card straight out of the slot.
4 Close the front door of the frame
Note: Detailed information about the rear panel connections is included in the user manual for
the card.
Using Densité 2 cards in the Densité 3+ FR1 Frame
The Densité 3+ FR1 frame supports Miranda Densité 2 series cards. Should you need to
install a Densité 2 card in your Densité 3+ FR1 frame, you will need two adapters – one for
the card, and one for the rear panel. These adapters extend the height of the Densité 2
devices so that they will fit into the slots of the Densité 3+ FR1 frame.
Card adapters
There are 3 different types of adapters that can be used, depending on the Densité 2 card
geometry:
• DENSITE 3-EXT-A
• DENSITE 3-EXT-B
• DENSITE 3-EXT-C