Belden Miranda DENSITE 3+ FR1, Руководство пользователя

Страница: 52 / 65

38
REF-1801-FR1 Frame Reference
Installation in the Densité 3+ FR1 frame
Installation in the Densité 3+ FR1 frame
The REF-1801-FR1 must be mounted in a Densité 3+ FR1 frame. The installation includes
both the REF-1801-FR1 module, and the rear panel module. It is not necessary to switch off
the frame’s power when installing or removing the card.
• The REF-1801-FR1 must be installed in the dedicated system card slot, above the right
side power supply of the frame.
• Install the rear panel before inserting the card into the slot.
Connection
All connections are made on the rear panel:
• Connect the input reference signal to one of the DIN 1.0/2.3 connectors marked REF IN .
The other REF-IN connector is a loop-through, which should be terminated if unused.
• Connect LTC time-code to the DIN 1.0/2.3 connector marked LTC IN
Fig. 4-5: REF-1801-FR1 rear panel
Operation
Control Options
The REF-1801-FR1 has two primary control interfaces:
• The local control panel attached to the Densité frame’s controller
• Remote control using Grass Valley’s iControl system
These are explained in detail in the following sections.
Local control using the Densité frame’s control panel
The REF-1801-FR1 can be controlled using the l ocal control panel , which is mounted on the
frame’s controller card.
See Using the local control panel on page 15 for a description of how to use this panel.
To assign the panel to control the REF-1801-FR1 card, push the Select button on the card’s
front edge. See Card Front Edge Layout on page 36.