Belden Miranda DENSITE 3+ FR1, Руководство пользователя

Страница: 32 / 65

18
CPU-ETH2 Controller Card
Network Configuration
6 Click [SEL] and [ESC] to select a number, and [+] and [–] to change its value.
7 When done, click [ESC] until the IP ADDRESS menu item appears.
8 Click [–] until NETWORK MASK appears in the display.
9 Repeat step 5 to step 7 above to set a new network mask value.
10 Click [–] until GATEWAY appears in the display.
11 Repeat step 5 to step 7 above to set a new gateway value.
12 Click [–] until MII STATUS appears in the display.
13 Click [SEL], and then click [+] or [–] until AUTONEGOTIATION appears.
14 Click [ESC] until ETH1 OPTIONS appears in the display.
15 Click [–] until ETH2 OPTIONS appears in the display.
16 Repeat step 4 to step 14 above to set up the ETH2 port.
17 Click the Controller button to exit the menu
You will now be able to access this controller from your local network using iControl or
iControl Solo.
iControl - click the Network button and select the ETH tab
The current IP address information for the
controller’s two ethernet ports is shown at
the bottom of the panel.
Enter the HOSTNAME in the box at the
top.
• The hostname is the unique name by
which this Densité CPU-ETH2 is
known on the network. The
hostname should be 15 characters or
less, and may contain only the ASCII
letters 'a' through 'z' (case-
insensitive), the digits '0' through '9',
and the hyphen.
The Ethernet Link Redundancy option is
configured in this panel.
Note that the option must be purchased
and activated before these controls become
available. See
Options , on page 30 for
details.
Mode: enable or disable the link redundancy function
Type: select one of the available bonding modes
• Round Robin
• Active Backup
See Options , on page 30 for more information about channel bonding modes.