Belden Grass Valley KMX-3921, Инструкция по установке и обслуживанию

Страница: 42 / 156

42
Multiviewer Cabling
Multiviewer Network Connections
Multiviewer Network Connections
The required network connections for the KMX-3921 multiviewer changes according to the
frame in which it is installed and the frame’s controllers model. The KMX-3921 multiviewer
can be installed in any one of the following frames.
Multiviewer SFP Module Mosaic Output to Display Input Cable
Connections
Connect displays to the SFP modules according to the following guidelines. Some SFP
modules have two outputs and in rare cases, the output allocation for these modules may
be reversed from what is shown. Configure the room layout in XEdit. The table below shows
the nomenclature used in XEdit and the physical SFP output on the multiviewer’s rear
panel. Connections crossed-out with a red ‘X’ are not connected. For more information
about the location of card A and B in the frame, see
Installation of the KMX-3921 in a
Densité 3+ Frame , on page 30.
Supported Frame Frame Controller Model Description Network Connection
Densité 3+ FR1 CPU-ETH2 frame
controller This frame controller
does not distribute
its network
connection with any
card in the frame. Connect the network
directly to the RJ-45
connector on KMX-3921
multiviewer’s rear panel for
each multiviewer installed
in the frame.
Make a second network
connection directly to the
ETH1 connector on the
rear of the Densité 3 frame.
Densité 3+ FR4 CPU-ETH3 basic frame
controller
a
a. See How to Identify a Densité 3+ FR4 Frame’s Controller Model , on page 22
Densité 3+ FR4 CPU-ETH3-STD
standard frame
controller
a
This frame controller
distributes its
network connection
to all cards in the
frame. Connect the network
directly to the
ETH1
connector on the rear of
the Densité 3+ FR4 frame
only.
Do not connect the
network to the RJ-45
connector on KMX-3921
multiviewer’s rear panel,
when present.
Densité 3+ FR4 CPU-ETH3-ADV
advanced frame
controller
a