Belden Grass Valley KMX-3921, Инструкция по установке и обслуживанию

Страница: 37 / 156

37
KMX-3921
Installation & Service Manual
Installation requirements
It is not necessary to switch off the frame’s power when installing or removing a card.
Each card has connectors which plug into a mid-frame mother board for distribution of
power and for connection to the controller card, and a second connector which for certain
cards plug directly into the rear panel for mosaic SFP output connections to the display(s).
Install the Multiviewer in a Frame
• To install the multiviewer in a Densité 3+ FR1 frame, see Installing Cards in the
Densité 3+ FR1 Frame in the Densité 3+ FR1 1RU Housing Frame for Densité Modular
Products User Manual .
• To install the multiviewer in a Densité 3+ FR4 frame, see Installing Cards in the
Densité 3+ FR4 Frame in the Densité 3+ FR4 Housing Frame User Manual .
See Related Documentation , on page 11.
Install the SFP Module(s)
Once the multiviewer has been installed in the frame, install the SFP module(s) into the
Rear Panel. See
Installing the SFP Output Module , on page 153.
IMPORTANT
First remove cards in any modular card slot where the rear panel is going to
be installed.