Bartec HYGROPHIL H 4230-10 A Series, Руководство по эксплуатации

Страница: 89 / 122

Maintenance
83
Operating Instructions HYGROPHIL® H 4230-10 Serie A BA 030520
● Clean both parts of the ejector. Use
a piece of cloth or brushes and a
detergent that is able to dissolve
the respective film of dirt.
Attention:
Never use sharp-edged objects to clean the ejector. The ejector gets waste
if its surface is scratched.
If this does not rectify the fault, the ejector is defective and must be replaced.
In this case, please contact your service centre.
Outlet channels and inlet connection
● Extract the two outlet channels from the lower section of the measuring
cell. When using measuring cell type 4230-115 or 116 you can also
extract the water inlet connection.
Attention:
Never extract the water inlet connection from measuring cell type 4230-107!
● Clean the interior of the outlet channels and the inlet connector using a
pipe cleaner.
Do not extract the water inlet connection
from measuring cell type 4230-107!