Bartec HYGROPHIL H 4230-10 A Series, Руководство по эксплуатации

Страница: 65 / 122

Operation
59
Operating Instructions HYGROPHIL® H 4230-10 Serie A BA 030520
4.4 Changing the slave address
The default slave address is 100.
If you wish to change the slave address, press the
F6
key in operating
mode.
The baud rate is then displayed briefly (if the device is working connected to
the bus).
Afterwards, the current slave address is displayed briefly.
You are then asked whether you wish to change the slave address.
0
or
ENTER

Don’t make any changes, return to the measured
value display
1

Change the slave address
If you answered the question by pressing the
1
key, you can now enter the
new slave address.
Confirm the entry by pressing the
ENTER
key.
The display briefly shows the new slave address before returning to the
measured values.
Baudrate
1.5 MBd
act. Slaveaddress
is 100
Change
Slaveaddr. ?
1/0
new Slaveaddress
= 100
new Slaveaddress
is 120