
Setup, Network and Communication Manual ESTM / ESTM-L
17-88C1-*
11-88C1-7D0002
Notice
Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
Page 22 / 35
4.8.6
Sensor Setup
Sensor mode:
Selection if one or both sensors are used
Controlled by
Sets the to be controlled value (Process control Value). Defines the
way the to be controlled value (Process control Value) is calculated
or which of both sensors is active.
Temperature Unit
Temperature unit selection. If you toggle it, all set values are
converted to the respective unit.
Sensor mode
Function
Description
action / - effects on / valid values ranges
Single Sensor
At the single sensor mode only one sensor is
activated the.
There is no need to connect a sensor to a not used
input. The fault detection for this input is switched
off
Process control Value
see 4.8.1 Controller
Both Sensors
At the two sensor mode, booth sensor are
activated then.
At both TC Inputs a Pt100 must be attached. Both
are monitored by the Sensor fault detection