Barco XDL-4K75, Руководство пользователя

Страница: 18 / 117

2. Pulse Remote Control Unit
C
AUTION
:
Replace with the correct battery type. Use two AA size batteries. There is a risk of explosion if the
battery is replaced with an incorrect type.
C
AUTION
:
Replace the battery as explained above. There is a risk of explosion if the battery is incorrectly
installed.
2.2 Remote control, protocol setup
About the used protocol
The protocol is the code send out by the remote control when a button is pressed. Depending on this code, the projector can decode
the signals. The remote control can be used with two different protocols, RC5 and NEC. Depending on the projector to control the
remote control can be switched between these protocols.
Which protocol to use
• The NEC protocol has to be used for Barco projectors based on the Pulse platform: F70, F80, F90, HDX 4K, UDX, XDL, etc.
• The RC5 protocol has to be used all other Barco projectors: HDX W, HDF W, HDX 2K, etc.
How to set
1. Remove the cover. For more info on how to remove, see "Remote control, battery installation", page 13.
2. Place the switch in the NEC position.
Image 2-4
Remark with RC5 protocol
Not all buttons of the Pulse RCU are one-to-one compatible with the legacy Barco RCU. Button pairs SHUTTER open/close and
POWER on/off emit the same code (per pair) when in RC5 mode, because the legacy RCU’s only had 1 button for Shutter and 1
button for Standby.
2.3 Remote control, on/off button
Purpose of the remote control on/off button
The Pulse remote control unit has at the front side an on/off switch (reference 1 image 2-5). Switching off the remote control prevents
that unwanted commands are send due to an accidental key press. Furthermore, switching the RCU off will extend the battery life
time of the remote control.
To activate the remote control press the on/off button.
To deactivate the remote control press the on/off button again.
Default when (re)placing batteries, is “ON”.
14 R5906151 XDL 17/04/2018