Barco XDL-4K75, Руководство пользователя

Страница: 36 / 117

4. Getting Started
2. Press the Input Selection button on the keypad or on the remote control until:
- the LED of the selected source (the “SEL” LED) light up GREEN, and
- the image of the selected source is projected.
1 2
Image 4-3
4.3 Switching to standby
About the switch off process
To switch off the projector in a safe manner to protect the internal electronics (avoid moisture due to warming up) the temperature
inside the sealed compartments has to be brought back to ambient in a controlled manner. This process is called
deconditioning .
How to switch to standby
1. Press and hold the Power on/off button for 3 seconds on the local keypad, or press the Power Off button on the remote control.
Caution: Do not switch off the power from the projector until the laser status light is off. Also make sure not to power off the
chiller(s). The chiller(s) should remain on as long as the projector is powered on.
The projector goes to standby mode. The deconditioning cycle will start and the lasers will be turned off. During this period the
Power on/off button will blink. Once the deconditioning cycle has ended, the projector will be in preconditioned state. If left alone,
the projector will eventually go into standby mode. In both states, the power on/off button will be lit WHITE.
Keep in mind that it can take up to 10 minutes to start the lasers again after they were switched off. If there
are only 30 to 45 minutes between the shows it’s advisable to keep the lasers on with shutter closed. When
the shutter is closed the lasers are automatically dimmed.
4.4 Projector ON/OFF cycle explained
Projector ON/OFF cycle
t
T
OFF
ON
LS
1
B
C
D
2 4 3 5 6 7 4 8
A
Image 4-4
LS
Laser Status light.
T Temperature inside sealed compartments.
t time.
A..D Operator manipulations.
1..8 Different process stages.
32 R5906151 XDL 17/04/2018