Bandit SG-75, Инструкция по эксплуатации и каталог запасных частей

Страница: 43 / 60

Bandit
41 Copyright 8/19
MODEL SG-75
Alternative hydraulic oils are available, but they do not equal the performance or longevity
of the “Hydrex XV” oil. Consult the following information supplied by the oil distributor.
HYDRAULICS
Some­component­manufacturers­require­­diff­erent­specifi­c­lubrication­requirements,­such­as­gear­boxes,­
undercarriage­drives,­fl­uid­engagement­clutches,­etc.­Refer­to­the­manufacturer’s­manual­for­information .
NOTICE
CELSIUS (C) -40 -34 -29 -23 -18 -12 -7 -1 +4 +10 +16 +21 +27 +32 +38 +43 +49 +54
FAHRENHEIT (F) -40 -30 -15 -10 0 +10 +20 +30 +40 +50 +60 +70 +80 +90 +100+110+120+130
PETRO CANADA HYDREX XV (245 VI)
HIGH VI - ANTI-WEAR HYD. OIL NO. 46 (>140 VI)
ANTI-WEAR HYD. OIL NO. 68
ANTI-WEAR HYD. OIL NO. 46
ANTI-WEAR HYD. OIL NO. 32
ANTI-WEAR HYD. OIL NO. 22
NOTICE
Go to: lubricants.petro-canada.com and click on “Contact Us” then click “Request
A­Quote”­to­fi­nd­your­nearest­Petro-Canada­dealer.
The above chart is a suggested guide for
viscosity­ of­ hydraulic­ fl­uids­ at­ start­ up­ ambient­
temperature. The load, demand, and cleanliness
of­the­equipment­will­aff­ect­actual­oil­temperatures­
which can increase dramatically above ambient
air temperatures during operation. The actual
viscosity needed is based on oil temperature during
operation and not air temperature. Compare your
fl­uid­specifi­cations­with­the­specifi­cations­below­
to verify compliance.
Based on the varying temperatures of the area
where Bandit equipment is used, and the high
demand and loads placed on this equipment,
Bandit has filled each hydraulic system with
Petro-Canada’s Hydrex XV All Season Hydraulic
Fluid for maximum protection and performance.
Minimum Viscosity during operation = 12 cSt
Maximum No-Load Viscosity at start-up = 2000 cSt
When­choosing­a­hydraulic­fl­uid­-­these­maximum­
and­minimum­specifi­cations­must­be­met :
Hydraulic fluids vary in their resistance to
oxidation at elevated temperatures, their ability
to protect against metal-to-metal contact under
increasing temperature, and their ability to separate
water­ from­ the­ fl­uid.­ Viscosity­ is­ temperature­
dependant. Fluids with high viscosity-index (VI)
will thin out slower at higher temperature and
thicken slower at colder temperatures allowing
a­wider­operating­range.­Choose­a­fl­uid­that­has­
test results in these areas for best results.
HYDRAULICS