Bandit SG-75, Инструкция по эксплуатации и каталог запасных частей

Страница: 31 / 60

Bandit
29 Copyright 8/19
MODEL SG-75 MAINTENANCE
3 MONTH MAINTENANCE
1. Change engine gear box oil:
Change­engine­gear­box­oil­after­first­50­hours,­then­
again every 3 months or 600 hours. Use Synthetic
SAE 90EP, Spirax S4 G 75W-90, or Traxon 80W/90
gear oil. Engine gear box oil capacity is 54 oz (1.6L).
2. Change cutter wheel gear box oil:
Change cutter wheel gear box oil after 50 hours, then
again every 3 months or 600 hours. Use Synthetic
SAE 90EP, Spirax S4 G 75W-90, or Traxon 80W/90
gear oil. Cutter wheel gear box oil capacity is 84.5
oz (2.5L).
3. Hydraulic oil filter:
Must­be­replaced­after­first­10­hours­of­operation,­
use­a­10­micron­filter.­After­first­change­replace­oil­
filter­every­3­months­or­400­hours.­Located­in­the­
hydraulic tank.
4. High pressure and charge filters:
Must be replaced after FIRST 10 HOURS OF
OPERATION. After first change replace high
­pressure­and­charge­filters­every­3­months­or­400­
hours.
1. Check hydraulic function pressures:
Check, reset and maintain all hydraulic function
pressure­ settings­ to­ a­ maximum­ of­ the­ specified­
PSI (bar). This will give you the best performance
from the hydraulic system.
MONTHLY
MAINTENANCE
3. Hydraulic suction screen(s):
Change hydraulic suction screen(s) yearly or every
2000 hours.
YEARLY MAINTENANCE
6 MONTH MAINTENANCE
1. Fuel tank:
Drain and clean the fuel tank yearly.
2. Hydraulic oil:
Change­hydraulic­oil­and­flush­the­hydraulic­­reservoir­
tank.
1. Change track motor oil:
Change­ track­ motor­ oil­ after­ the­ first­ 500­ hours,­
then again every 6 months or 1000 hours with SAE
80W/90 gear oil.
250 HOUR
MAINTENANCE
1. Grease drive shaft:
Grease drive shaft with 2 shots of an EP-2 Lithium
type­ grease­ every­ 250­ hours.­ Wipe­ off­ excessive­
grease. Excessive grease will attract dirt.
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION BOLT SIZE TORQUE (FT.-LBS.) TORQUE (NM)
Cutter Wheel Revolution Lead Tooth Nut 5/8” - 18 NF 200 271
Cutter Wheel Revolution Side Tooth Nut 5/8” - 18 NF 125 169
Cutter Wheel Green Tooth Pocket Bolts 5/8” - 18 NF 125 - 150 169 - 203
Cutter Wheel Green Tooth Nut N/A 31 - 43 42 - 58
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved knives and hardware.
BOLT TORQUE CHART