Bandit SG-75, Инструкция по эксплуатации и каталог запасных частей

Страница: 32 / 60

Bandit
30 Copyright 8/19
MODEL SG-75 MAINTENANCE
1. Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. cutter wheel guard, control box doors, etc.)
2. Check alternator and fan belts on engine, adjust, or replace.
WEEKLY CHECK LIST
Every week these checks must be made:
OK REPAIRED
1. Check hydraulic function pressures. Set to specified PSI (bar).
MONTHLY CHECK LIST
Every month these checks must be made:
OK REPAIRED
1. Grease drive shaft with 2 shots.
250 HOURS CHECK LIST
Every month these checks must be made:
OK REPAIRED
1. Change engine gear box oil. Gear box oil capacity is 54 oz (1.6L)
2. Change cutter wheel gear box oil. Gear box oil capacity is 84.5 oz (2.5L)
3. Replace hydraulic filter(s) after first 10 hours then quarterly or
every 400 hours. Located in the hydraulic tank.
4. Replace high pressure and charge filters after first 10 hours, then
quarterly or every 400 hours.
3 MONTH CHECK LIST
Every three months these checks must be made:
Each day before starting your machine these checks must be made:
1. Check the safety decals and engine gauges, replace if damaged.
2. Check, maintain, and service all safety equipment for proper operation.
3. Check entire machine for loose nuts, bolts, and components.
4. Check all guards to make sure they are tight and securely in place.
5. Check the condition of the cutter wheel and tooth pockets.
6. Check the condition of the cutter teeth, pockets, and hardware.
7. Properly torque cutter wheel pocket bolts.
8. Grease lower pivot pin bushings with 1 to 2 shots.
9. Grease cylinder lug pin bushings with 1 to 2 shots.
10. Check and always maintain hydraulic level at 7/8 full.
11. Check all hoses, fittings, lines, and tanks for damage and fluid leaks.
12. Check fuel level. (Running out and repriming is time consuming).
13. Check engine oil, coolant levels, and correct engine speed. Follow ENGINE
MANUFACTURER’S manual specs.
14. Check radiator and debris screen. Clean as necessary. Clean cooling fan and
shroud on air cooled engines.
15. Check oil cooler. Clean as necessary.
16. Check air cleaner, precleaner, and vacuator valve. Clean or replace as necessary.
17. Check machine controls and ensure they operate and shift correctly.
18. Check track assembly for wear and damage. Repair or replace as necessary.
19. Lubricate track expansion tubes assembly, apply dry lube.
20. Check around the entire machine for any foreign objects, tools, cans, saws, etc.
21. Review all safety procedures on decals, from manual, and from video.
22. Wear all applicable safety equipment: hard hat, face shield, gloves, eye
protection, ear protection, etc.
23. Remember to check EVERYTHING on the checklist.
DAILY START UP & MAINTENANCE CHECK LIST
OK REPAIRED