Bandit SG-75, Инструкция по эксплуатации и каталог запасных частей

Страница: 46 / 60

Bandit
44 Copyright 8/19
MODEL SG-75 HYDRAULICS
HYDRAULIC SYSTEM TROUBLESHOOTING
When returning hydraulic components for warranty make sure to box up all warranted parts to avoid additional
damage while shipping. Do not disassemble any hydraulic components which are to be warranted.
Anything which has been disassembled or tampered with will not be warranted. Items being returned must
be clean. All hydraulic components must have all hosing ports plugged. Failure to plug ports will allow debris
to enter components which will void warranty.
NOTICE
In cold weather situations, let the hydraulic system idle for approximately 15 minutes to allow the system
to warm up to operating temperature. Running cold oil through the hydrostatic motor can raise the case drain
pressures and damage the shaft seals.
NOTICE
Before attempting any type of maintenance, disengage clutch or cutter wheel engagement, wait for the
­cutter­wheel­to­come­to­a­complete­stop,­position­and­lock­the­cutter­wheel­in­the­transport­position,­turn­off­
engine, remove the ignition key, make sure the ignition key is in your possession, install the cutter wheel lock
pin, wait 2 minutes then disconnect the battery.
DANGER
!
PROBLEM POSSIBLE CAUSE SOLUTION
Hydraulic oil very hot causing
system to operate slowly.
Dull Teeth Replace teeth
Low oil level Fill 7/8 minimum
Worn pump Replace
Poor oil quality Replace
Damaged hose Replace
Oil­suction­screen­or­filter­plugged Replace
Oil cooler plugged Clean
Binding Repair
Hydraulic system loss of power.
Low oil level Fill 7/8 minimum
Poor oil quality Replace
Bad cylinder Replace or repair
Bad pump Replace
Bad motor Replace or repair
Relief stuck open Clean or replace
Swing cylinder loss of power. Bad cylinder Replace or repair
Cutter wheel swings faster one
way than the other way.
Bad cylinder Replace
Cutter wheel does not stay in
up position, creeps down.
Bad cylinder Repair or replace