Bandit SG-75, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 60

Bandit
10 Copyright 8/19
MODEL SG-75 SAFETY PROCEDURES
SAFETY PROCEDURES
Check laws and regulations. Know and obey all
federal, state, and local laws and regulations that
apply to your work situation and the transportation
of a machine this size.
WARNING
!
CLEAN MACHINE OF ALL DEBRIS! DO NOT
leave­this­machine­unattended­until­all­potential­fire­
debris­is­removed,­no­fire­or­­smoldering­exists,­and­
hot spots are cold. The engine creates many hot
spots including: exhaust manifold, exhaust, turbo (if
equipped),­etc.­Remove­all­flammable­debris­such­
as wood, chips, leaves, oils, fuels, etc. from engine
exhaust, engine turbo (if equipped), beside, around,
and under engine, around and under tanks, inside
belt shields and guards, inside battery and tool
boxes, inside cabinets (if equipped), and anywhere
­materials­collect.­ALWAYS­keep­several­type­A:B:C­fire­
extinguishers operational and on the job at all times.
WARNING
!
WARNING
!
Sparks can occur if cutter teeth strike rocks, metal,
or other hard objects.
­ DO­ NOT­ use­ in­ high­ or­ very­ high­ fire­ hazard­
severity zones.
Operation of this equipment may create sparks
that­can­start­fires­around­dry­vegetation.­A­spark­
arrester may be required. The operator should
­contact­local­fire­agencies­for­laws­or­regulations­
relating­to­fire­prevention­requirements.
Do Not continue to operate the machine if the
cutter wheel stalls. Immediately lift cutter wheel out
of the stump, dirt, etc. and start again with less bite.
Prolonged cutter wheel stall will ruin the drive system,
creating­extreme­heat­and­possible­fire­hazard.
WARNING
!
Before performing maintenance on the machine
remove all debris, oil, grease, water, snow, ice, etc.
from all machine surfaces.
WARNING
!
DANGER
!
Keep hands clear of all pinch points.
DANGER
!
Do not touch hot machine surfaces. The machine
surfaces may be hot due to the machine operating
recently or the machine setting in the sunlight.
WARNING
!
Unless going through a narrow passageway or
gate, always keep the dual tires installed or the tracks
expanded for machine stability.