baltur GI 1000 DSPN-D, Инструкция по эксплуатации

Страница: 26 / 68

22 / 28
0006080844_201003
E
N
G
L
I
S
H
Notes on the programmer
Programmer sequence
Output signals
on terminal
Times Legend
time (50 Hz) in seconds
31.5............t1 Pre-ventilation time with air damper open
3.................t2 Safety time
- .................t2’ Safety time or safety time with burners that use pilot burners
6.................t3 Short pre-ignition time (ignition transformer on terminal 16)
- .................t3’ Long pre-ignition time (ignition transformer on terminal 15)
12...............t4 Time between beginning of t2’ and valve consensus on terminal 19 with t2
- .................t4’ Time between beginning of t2’ and valve consensus on terminal 19
12...............t5 Time between end of t4 and consensus at power regulator or at valve on terminal 20
18...............t6 Post-ventilation time (with M2)
3.................t7 Time between consensus for start-up and voltage at terminal 7 (start delay for fan motor M2)
72...............t8 Start-up duration (without t11 and t12)
3.................t9 Second safety time for burners that use pilot burners
12...............t10 Time from start-up to beginning of air pressure control without air damper travel time
t11 Air damper opening travel time
t12 Air damper in flow flame position (MIN) travel time
18...............t13 Permitted post-combustion time
6.................t16 Initial delay of consensus for air damper OPENING
27...............t20 Time up to automatic closure of programmer mechanism after burner start-up
NOTE:
With voltages at 60 Hz, the times are reduced by about 20%.