44
Owner’s Manual Baldertech Balder
| Baldertech
9. TROUBLESHOOTING
1
What do you do when
the chair is completely
dead?
•
The chair is unpowered.
•
Fault in the electronics.
•
Fault in the electrics.
• Remove the charge con-
tact.
• Check that the on/off
switch is set to On.
• Check that the magnetic
key is not activated.
• Check that the switch-
es for disconnecting the
motor are in “Operation”
position.
2
The chair can be moved
but none of the electrical
functions are working?.
•
Fault in the electrics.
•
Contact your dealer.
3
The chair will not accept
a charge.
•
Fault in the charger.
• Poor contact in the charge
contracts / cable.
•
Fault in the electronics.
•
Defective batteries.
•
Plug in the chair.
• Make sure that the indica-
tor lamp on the charger is
on.
• If the indicator on the
charger is not on, there is a
fault in the charger.
•
Contact your dealer.
4
The chair’s indicator lamp
flashes once, with two
seconds’ gap between
flashes.
•
The joystick has to be
purged of data for the rest
of the system.
•
Leave the chair on for 10
seconds, switch it off for 10
seconds, then switch it on
again. The chair should be
ready for operation.
5
The chair’s indicator lamp
flashes twice, with two
seconds’ gap between
flashes.
•
The speed limited for the
seat lift has been activated.
•
Fault in the electronics.
•
Not a fault. Lower the seat
height until it is below the
speed reduction limit.
•
Contact your dealer.
6
The chair’s indicator lamp
flashes several times,
with two seconds’ gap
between flashes.
•
Fault in the joystick.
•
Fault in the electronics.
•
Fault in the cable.
• Count the number of
flashes, then contact your
dealer.
7
The chair is difficult to
move.
•
Incorrect operating pro
-
gram.
•
Incorrectly adjusted pro
-
gram.
•
Select a different operating
program.
•
Contact your dealer.
8
The speed of the chair is
suddenly halved while it
is moving.
•
Seat position too high.
•
Fault in the speed limiter.
• Check the seat height as
the chair is fitted with
speed reduction.
9
Electric back function
and electric tilt move
forwards only.
•
Not a fault.
•
Fault in the limiter switches
and/or diodes.
• Raise the seat so that the
limiter switches are not
enabled.
•
Contact your dealer.
10 A part seems loose.
•
Not tightened enough.
•
Threads stripped.
• Incorrect assembly
•
Impact or vibration dam
-
age.
•
Check fitting or tightening.
•
Tighten loose screws.
• If you are not sure what is
wrong or how you should
fix it, contact your service
partner.
11
Lift, tilt or back function
moves in one direction
only
•
Fault on the tilt switch
•
Fault in the electronics.
•
Trap guard activated if this
is mounted on your chair.
• Check whether there are
any foreign bodies in the
cover, and remove these.
•
Contact your dealer.
These points are intended to provide simple guidance. Contact your dealer for further assistance.
