30
Owner’s Manual Baldertech Balder
| Baldertech
The stand up function
1. Move the seat and back to the required starting position (cf.
sections 5.2.1 and 5.2.2)
2. Move the footrest to the required starting position (cf. sec
-
tions 5.2.3 and 5.2.4)
3. Activate the seat raise function (cf. section 5.2.5).
4. Raise the seat until you are at the correct height. The cor
-
rect height is indicated by a yellow light which comes on in
the vertical function panel (1).
5. Push the lower part of the lock pin up, so that it sticks
straight out (2a). Thread the buckle of the knee brace cush
-
ion into the fixing bracket. Push the lock pin back, so that it
remains straight up, with the broadest part of the lock pin
facing down. The lock pin is now in the lock position, and
the knee brace cushion is ready for use of the stand up
function (2b). The knee brace cushion must be tight below
the knee.
6. Put on the breast belt (3) and tighten it
7. Activate the stand up function by holding down the stand
up function switch (4).
8. Move the chair to the upright position, the support legs (5)
will automatically be lowered when the seat angle exceeds
15 degrees. A green light (6) comes on when the support
legs are activated.
Return to the starting position
1. Press and hold down the switch (7) to deactivate the
standing position and return to the starting position.
5.4. Interference
NOTE
When the chair is activated, it may affect electrical equipment which contains radio transmit
-
ters/receivers.
If the chair stops, check the automatic fuse as described in section 5.4.1. If you need to push the
chair, the chair can be disconnected as described in section 5.4.2.
See also section 9, or contact your dealer if you require assistance.
