38
Owner’s Manual Baldertech Balder
| Baldertech
6.3.2. BALDER DOCKING SYSTEM
WARNING
Do not move vehicles until the wheelchair is in the correct position, this is
indicated by a green light in the control panel on the chair.
NOTE
If you fail to get out of the clamp down unit, a flashing red light will be displayed for 90 seconds
after five attempts and the clamp down unit will remain inactive for this period in order to pre
-
vent the release solenoid overheating. The clamp down unit will be ready for use again after 90
seconds.
NOTE
There is a manual release. It is located down at the back of the chair, push the lever down while
releasing the chair using the joystick or do it manually.
Attaching the chair to the docking station
1. Roll the chair into the docking station (1).
2. When the chair is in the correct position, a green light (2)
will appear in the car bracket panel.
Removing the chair from the docking station
1. To remove the chair, hold down the switch (4) on the
switch panel until a green light starts flashing (2).
2. Move your hand to the joystick. A red light comes on
when the chair is released (3).
3. Remove the chair from the docking station within three
seconds. The indicator lamp (2) goes out once the char
-
acter is free of the docking station
NOTE
If you do not remove the chair from the docking station
within three seconds, or if you decide not to remove the
chair, the chair will be locked back into the car bracket and
the green light (2) will come on if the chair is in the correct
position.
Repeat the process if necessary.
