Baker Hughes Druck DPI 610 IS, Инструкция по эксплуатации

Страница: 33 / 76

Copyright 2007 Baker Hughes Company.
English–DPI 610/615 IS Instruction Manual | 23
Process Functions
Note: Display shows the last entered Tare Value.
5.4.2 Min/Max Process Function
To set-up an input display to show min/max and present input reading, enable MIN/MAX from the
process menu and press F1 (SETTINGS) to provide
RESET
function. The display now shows the
max/min values as follows:
Reset Max/Min display at any time by pressing the F1 key.
To quit max/min, press
INPUT , select MAX/MIN from process menu and switch the function off.
5.4.3 Filter Process Function
To apply the low pass filter to a selected input, enable FILTER from the process menu and press
F1 (SETTINGS) to provide access to the filter parameters. Two settings are required, Time to
Settle and Band.
To examine the current filter settings and exit without change, press the
EXIT key.
The set-up procedure is as follows:
TASK : ADVANCED
SNAPSHOT MODE
VOLTAGE
PRESSURE INT
MAKE READING
ZERO
TARE OFF
A VALUE
TASK : ADVANCED
SNAPSHOT MODE
VOLTAGE
PRESSURE INT
ENTER VALUE
VALUE: 10.000
NEW VALUE: _
TASK : ADVANCED
SNAPSHOT MODE
VOLTAGE
PRESSURE INT
RESET
MAX/MIN
MAXIMUM
PRESENT
MINIMUM
SET FILTER
SELECT VALUE SELECT VALUE
CHANGE
VALUE
CHANGE
VALUE
TIME TO SETTLE
TIME =
2
Seconds
TIME TO SETTLE
TIME = 2 Seconds
SET FILTER
BAND = MAX AMPLITUDE
OF NOISE TO BE
FILTERED, CHANGES
GREATER THAN BAND
BYPASS THE FILTER
BAND = 1.5 % FS
BAND = MAX AMPLITUDE
OF NOISE TO BE
FILTERED, CHANGES
GREATER THAN BAND
BYPASS THE FILTER
BAND =
1.5
% FS