INSTALLING SOFTWARE
DOS UTILITIES - EXAMPLES
A - 6
I-E96-107-2N
®
(ALTA)
Install the Alta Diagnostic disk in the floppy drive and at the
DOS prompt, enter the commands:
xcopy a:\*.* c:\alta /s
Upon completion, switch to drive “C” and enter the commands:
cd \alt
alta
Follow the menus displayed on the screen.
Record the unit's Ethernet address in the Network Planning
Form (
), as it will be required for configuring the
network later on in the OIS12 software installation process.
The Ethernet address is twelve digits long, it consists of four
sets of three hexadecimal numbers. Hexadecimal numbers
also use the letters A-F as well as digits 0-9. An example is 00C
093 00D B4F
[ATI]
Insert the ATI GRAPHICS ULTRA+, or Ultra Pro disk 1 of 3 into
the floppy drive. At the DOS prompt, enter the command:
a:install
Select
Install Video Adapter Utilities
and accept the default direc-
tory. Follow the instructions displayed on the screen.
When the Main Selection menu re-appears, select the
Set
Power-Up Configuration.
On the Set Power-Up Configuration menu, select the following:
•
Monitor Type:
on the pop-up menu select
Custom,
1024x768, 72Hz non-interlaced
if the computer is a DEC.
Press
<Esc>
to return to the Set Power-Up Configuration
menu. If the computer is an HP, select
Custom, 1024x768,
72 Hz non-interlaced.
•
VGA ROM Configuration
: on the pop-up menu select
16 bits.
Press
<Esc>
to return to the Set Power-Up Configuration
menu.
•
Mouse Configuration:
if you have a three-button ATI Bus
Mouse then on the pop-up menu select
Primary Address
(23 Ch) and IRQ2
. Press
<Esc>
to return to the Set
Power-Up Configuration menu. If you have a two-button
DEC Bus Mouse, leave Mouse disabled.
•
VGA Bus I/O:
on the pop-up menu select
16 bits.
Press
<Esc>
to return to the Set Power-Up Configuration menu.
