INSTALLING SOFTWARE
DOS UTILITIES - EXAMPLES
I-E96-107-2N
A - 5
An
A
in the status field shows that this partition is now active.
The following message will appear after the partition is set
active and you escape from the fdisk program:
System will now restart
Insert DOS diskette in drive A:
Press any key when ready...
Put the DOS setup disk in the floppy drive and press any key
to restart DOS.
The 20 megabyte primary DOS partition has now been created
and set active. This partition must now be formatted and made
bootable.
The MS-DOS 6.0 setup program will now run, it will copy all
the DOS files into the c:\DOS directory, created by the pro-
gram. When asked if you want the setup program to continue
press
<Enter>
to continue and accept all the defaults. The pro-
gram will give you a choice to format the new partition. Select
Format Partition
and press
<Enter>.
The setup program will cre-
ate an “autoexec.bat” and a “config.sys” file.
Create DOS Bootable Disk
Place a blank disk in the OIS12 console drive “A”. Enter the
following command:
format A: /S
This will create a bootable DOS disk. Label it as such and store
with the OIS12 disks included with the OIS12 console.
DOS UTILITIES - EXAMPLES
Adapter Card Utilities
Some of the adapter cards installed in the OIS12 console (e.g.,
graphic cards, network cards) have provided a utility or config-
uration disk and user’s guide. These utilities should be
installed in the DOS partition of the hard disk, using the
instructions provided in the adapter card's user's guide.
Create the following directories on the “C” drive, using the
name shown in square brackets by typing:
md (dirname)
<
Enter
>
