Baileigh Industrial BSVT-18P, Руководство оператора

Страница: 47 / 56

44
44
Once the feed pressure has been set, you should then set the feed rate. The location on the
operator’s control panel of the machine. This control regulates the maximum speed at which the
blade will move forward under a given pressure. In general, this should be set to move at a rate
of 7 to 10 linear inches of travel when there is no material in the saw.
Time the cut. If your cutting rate is approximately equal to the cutting rate prescribed by your
bandsaw blade manufacturer, you need not make any adjustments for subsequent cuts from
that same material. If you are cutting too slowly according to that recommendation, gradually
increase the feed rate over the next several cuts. If you are cutting too quickly, gradually
decrease the feed rate over the next several cuts.
This is sadly and admittedly not as scientific as any of us would like it to be. It is, unfortunately,
less than a scientific process. It will require some experimentation on your part to find exactly
the right settings for your material. When you have found the settings that are best for you be
sure to record them, so you know when you cut the same job again.