Baileigh Industrial BSVT-18P, Руководство оператора

Страница: 30 / 56

27
27
Feeding Stroke
The cutting head can be fed forward or backward manually by rotating the feed handle
counterclockwise or clockwise, respectively.
The saw also can be fed forward automatically by adjusting the feed force knob clockwise until
the desired feed is obtained.
The stops will set a forward travel limit which will stop the blade and retract the saw bow to the
start position. The forward stop should be adjusted about 1/4" (6.3mm) past the point where the
blade exits a cut.
To adjust:
1. Manually feed the saw bow forward to a position in
which the teeth of the saw blade are at least 1/4”
(6.3mm) past the farthest thickness of the material
to be cut.
2. Hold the saw bow in this position and adjust
forward stop to contact the Carriage Stop Bracket.
3. Note the position of the forward stop block as
compared to the scale on the side of the frame.
This can then be used to fine tune the desired stop
position.
4. When the stop bracket contacts the forward stop,
the cutting head will automatically stop its forward
movement, the blade will shut off, and the saw bow
will return to the start position.
5. Set the rear stop in the same manner.