Baileigh Industrial BSVT-18P, Руководство оператора

Страница: 44 / 56

41
41
5. Determine the angle of the cut. Use the lock lever to loosen the saw bow and manually tilt
the bow from 45
°
left tilt to 45
°
right tilt. Never rely solely on the scale markers for the correct
tilt angle. Always verify the angle with a protractor.
6. Mark the material for the location and angle of the cut.
7. Place the material between the vise plates. The vise may be positioned on either side of the
cut and has other forward and aft adjustments.
8. Align the cut mark with the saw blade.
9. Close the vise to clamp the material.
10. Turn the coolant switch to On to start the coolant flow. Adjust the flow at the nozzle using the
ball valve located at the nozzle.
11. Press the Start switch to start the saw blade and advance the saw bow into the cut.
12. Adjust the saw blade speed using the adjustment knob on the right side of the console and
monitoring the speed using the blade speed indicator. Set the speed so that the speed is
±5SFPM of the desired setting. Getting an exact match will be difficult.
13. Set the Feed pressure to a pressure as recommend from the pressure chart.
14.
Press the “STOP” button to stop the bow movement if needed.
a. The saw bow will advance until the forward stop limit switch is engaged. Then the saw
blade will stop, the frame will retract to the home position and wait for the next cut
cycle.
15. Slowly turn the feed speed knob counterclockwise (ccw) until the feed speed is set. This
value is the “Cutting Rate” from the Cutting Chart. It is listed in Surface Inches Per Minute
(SIPM).
16. Once the feed rate and pressure are set, lightly tighten the lock knobs to hold these setting.
This will keep the settings for as long as the same material will be cut.
17. When the cut is complete, (either by the feed stroke limits or by the operator pressing the
stop button) the saw blade will stop and the saw bow will retract to the start position.
18. Once the saw frame has returned to the home position, the saw may be set for the next cut.
a. This will be determined by each specific project to be sawn.
NOTE: It is recommended to check the first cut for accuracy. Make any
adjustments before cutting the remaining stock. If the saw frame is not set at 0
°
the saw will not
cut squarely.
19. When the saw is not in operation, power the saw down by pressing the E-Stop. If leaving the
saw unattended, turn the main disconnect to Off.