Baileigh Industrial BSVT-18P, Руководство оператора

Страница: 33 / 56

30
30
Adjusting the Blade Guides
The guide bearings are mounted on an eccentric shaft which is used to apply the guide pressure
to the side of the band saw blade to hold the blade in a straight line within the cut window of the
blade.
1. DISCONNECT POWER FROM THE BAND SAW.
2. Check to make sure the guidepost is secure, and the blade has been properly tensioned.
3. Loosen the lock nut (A) while holding
the adjuster (B).
4. Turn the adjuster to set the bearing to
just barely touch the blade (0.003").
This clearance can be measured with a
piece of thin paper which should just fit
into the gap between the bearing and
the blade.
5. Hold the adjuster and tighten the lock
nut.
6. Set the lower blade guide bearing in
the same manner.
7. When correct guide bearing adjustment
is done, the blade runs smoothly and
evenly without twisting or snagging
anywhere along its path.
A
B