26
Airbag System
1
The front airbag mainly consists of three parts:
●
Electronic control and monitoring device.
●
Two front airbags with gas generators.
●
The airbag fault warning light is located on
the display screen of the information center of
the combination instrument.
The airbags are monitored by the electronic
monitoring system of the airbag control unit.
When the ignition switch is in the “ON”
position, the airbag fault warning light will be lit
for several seconds and then go out after
self-detection is completed.
In the event of a serious frontal collision, the
front airbags will act as a supplement to the
three-point seat belt and protect the head and
chest of the driver and the front passenger.
The airbag system cannot replace the seat belt.
It is only one part of the passive safety system
of the vehicle. Please note: The airbag system
can play its protective role to the greatest extent
when the seat belt is correctly fastened and the
headrest is correctly adjusted. Therefore, it is
necessary to always wear a seat belt, not only to
comply with regulations, but also to serve safety
needs.
Warning
●
Make sure to go to an authorized BAIC
dealership to have the airbag system checked
and repaired.
●
Do NOT try to refit the front bumper or
any of the vehicle body structures on your
own.
Caution
The deployment or shrinkage of the frontal
airbag is completed within a very short
period of time. The airbag cannot play a
protective role against secondary impacts
that may subsequently happen.
To ensure that the frontal airbag can correctly
deploy and unfold, there should be no blocking
objects between the frontal airbag and the
passenger.
Caution
Placing any subjects near or over the steering
wheel, the dashboard and the airbag
assembly, inside the dashboard, or above the
passenger-side glove box is prohibited. This is
because, when the vehicle is involved in a
collision serious enough to deploy the airbag,
these subjects will fly out and cause injuries.
