46
ACCESSORIES & FEATURES
ACCESSORIES & FEATURES
47
ONLY USE BABYLOVE SEAT COVERS THAT ARE DESIGNED AND TESTED FOR USE WITH THIS
PRODUCT.
The following instructions apply to accessories that may be supplied with this restraint at point of
purchase. If not, a variety of accessories are available from
various retailers of Babylove products.
CROTCH PAD (IF FITTED)
The Crotch Pad is designed to provide extra comfort for baby
or child and is fitted to the restraint as follows: Feed Crotch
Buckle through the slot in crotch pad as shown.
PADDED INSERT (IF FITTED)
The Padded Insert is designed to snugly support the baby for
extra comfort. Simply place the padded insert on the restraint
between Harness straps and the restraint back. Ensure
padded insert is lined up with or below the shoulder straps.
Discontinue use if the Insert causes discomfort or when the
child's shoulders reach the Middle Shoulder Height Marker.
This will allow the child to use the in-built harness longer.
Messy Mat
Crotch
Pad
Padded
Insert
Head
Pillow
Shoulder
Pads
COVER
The restraint has a flame retardant cover which is removable for cleaning. Cleaning instructions are on
the care label attached to the cover. When washing cover engage hook & loop strips together to eliminate
other garments being caught.
The cover has been designed to protect your child when seated in the restraint. Care should be taken if
children either eat or drink while in the restraint as some food or drink products may cause damage or
marking to the cover.
IMPORTANT:
Do not pull sticky items from covers as the cover may be damaged - soak in water and gently remove.
TO REMOVE COVER
Follow the sequence below
A to G
(anti clockwise) to remove the cover.
REPLACE COVER
To replace cover refit in reverse sequence G to A.
• For the in-built harness or toddler mode, refit the harness through the same shoulder strap slots refer to
pages 13 to 14 for harness adjustment and setup.
• For the Booster Seat mode, refit the cover and the sash guide should be in the same position. If the
sash guide has fallen out of the slot refit by following the steps on page 23 to 26.
• If a child harness was fitted in the Booster Seat mode then follow steps on pages 32-42 to refit the
Child Harness.
If the sash guide is in Booster Seat mode the sash guide can be left in place for washing.
If Child Harness is fitted remove the Child Harness.
C.
Unhook Elastic Loops.
D.
Peel trim away from seat.
A.
Disengage harness tongues from crotch buckle.
G.
Peel
cover away
from shell.
B.
Unhook the strap connector
from the back of the restraint
and feed the Shoulder and Lap
Harness straps through the
cover, (If applicable).
F.
Feed crotch
buckle and harness
adjustment
strap through
slot in cover, (If
applicable).
E.
Unhook Elastic Loops
from under the restraint
Strap Connector