52
53
CHILD RESTRAINTS MUST NOT BE ATTACHED TO
UNSOUND METAL OR TO WOOD, OR SYNTHETIC
STRUCTURES. WHEN DRILLING 9 MM HOLE DO NOT
DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL
WIRING, OR RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM SHARP
CORNERS AND EDGES. THE ANCHOR FITTING MUST BE
USED ONLY AS DESCRIBED ABOVE. IT MUST NOT BE
HOOKED ONTO ANY OTHER OBJECT.
PRE-INSTALLATION ANCHOR FITTING
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE BOLT IS NOT THE
CORRECT LENGTH THE CAR MANUFACTURER’S HAND BOOK
CAN PROVIDE ADVICE ON THE CORRECT LENGTH BOLT.
PRE-INSTALLATION ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD
RESTRAINT ANCHORAGE POINT
Locate the anchorage point behind the rear seating position.
(consult the car owners handbook for the location of the
anchorage point). The anchorage point should be directly
behind and central to the restraint. Remove thread plug from
the parcel shelf/floor/roof, etc. and install anchor bolt and
fitting as shown in Fig.1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 N.M.
(14.75 ft.lb.)
Note: Minimum of five full turns of anchor bolt is required
before tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT ANCHORAGE POINTS
For Sedans only
- Drill 9mm diameter hole in the parcel
shelf on the centre line of the seating position as shown
in Fig.3. Before drilling the hole, check the underside for
accessibility. Install the anchor bolt as shown in Fig.2.
For vehicles other than Sedans
- In Australia, consult your
nearest child restraint fitting station or traffic authority for
vehicle inspection to find the best, correct position for
the placement of the anchorage point, and for the correct
attachment bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
Note to Queensland purchasers: The installation of
anchorage points must be approved by authorised officers
appointed by Queensland Transport. Authorised officers can
be sourced from all Queensland Transport Customer Service
and Queensland Ambulance Service Centres.
Front of Vehicle
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Secure nut
UPPER ANCHORAGE
FITTINGS FOR SEDANS ONLY
Vehicle trim
Fig.2.
UPPER ANCHORAGE FITTING
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Vehicle trim
Fig.1.
Note: Marking on the top
of a Grade 5 Bolt.
Front of Vehicle
Centre line of
seating position
Fig.3.
200mm
min.
VEHICLE INSTALLATION ACCESSORIES
(Available from retailers of Babylove products)
EXTRA ANCHOR KITS:
Are available if using the restraint in additional vehicles.
Re-order number: K402
EXTENSION STRAPS:
May be required for vehicles without a fixed parcel shelf.
Re-order number: K304 (length 300mm)
or K305 (length 600mm).
GATED 3-BAR SLIDE:
For converting lap-sash seat belt to lap belt for the Child Harness (supplied with the
Child Harness) Also to obtain a better fit to the car where the seatbelt may loosen although most cars will
not need this.
Re-order number: K403.
