Pro-Stitcher Lite for the Baby Lock Gallant/Villa Frame
Installation Instructions | 19
Verify the Alignment
Â
IMPORTANT
: If necessary, use your hand to
engage the black gears before placing the
machine on the carriage. (See page
for
more information.)
1. Place the Pro-Stitcher Lite tray assembly with
the carriage on the frame with the power cord
connection and encoder toward the back of the
frame. Carefully lift the Gallant quilting machine
and place it on the carriage so the wheels
engage the black carriage tracks. Make sure not
to set the wheels on top of the encoder cables.
This is easier to do with two people, one at each
end of the quilting machine.
2. Verify that the black Y-axis gear engages the
blue Flexirack for the Y-axis at the front and
the rear of the Y-rack. To do this, look from
the back of the machine between the bottom
of the quilting machine and the top of the
carriage. If necessary, use your hand to rotate
the lifting cam eccentrics until the gears are
engaged. This will need to be done on the
underside of the carriage before it is placed
onto the frame.
3. Ensure that at least two-thirds of the black
y-axis gear and blue Flexirack are interlocking
the entire length of the rack. Some horizontal
adjustments may be necessary. If so, loosen
the four screws that mount the Y-axis bracket
to the base plates and push the bracket in the
necessary direction, hold it in place, and then
retighten the screws.
NOTE
: The screws can be adjusted with the
quilting machine on the carriage. Pull the
machine to the front to access the front
screws and to the rear to access the rear
screws.
NOTE
: You will need to lift the rear wheel
up and over the back wheel stop in order to
access the two rear screws. Have a second
person stabilize the machine while you make
the adjustment.
4. Pull the quilting machine to the rear of the
carriage and ensure the rear of the Y-axis
bracket does not collide with the black plastic
track retainer on the rear of the carriage. Adjust
the Y-bracket if needed.
